REMOVAL
1.

Disconnect the battery negative cable, and wait for at least three minutes before beginning work.

2.

Remove the front seat assembly. (Refer to BD group)

3.

Remove the center pillar trim. (Refer to BD group)

4.

Disconnect the Seat Belt Pretensioner connector.

5.

Remove the lower anchor bolt.

6.

Remove the upper anchor bolt.

7.

Loosen the Seat Belt Pretensioner mounting bolt and remove the Seat Belt Pretensioner.

INSTALLATION
1.

Disconnect the negative (-) cable from battery and wait for at least three minutes.

2.

Remove ignition key from the vehicle.

3.

Install the Seat Belt Pretensioner (BPT) with bolt.

4.

Install the upper and lower anchor bolts.

Tightening Torque (Seat Belt Anchor Bolt)

: 4.0 ~ 5.5 kgf.m (39.2 ~ 53.9 Nm, 28.9 ~ 39.8 lb.ft)

5.

Install the center pillar trim.

6.

Install the front seat assembly.

7.

Reconnect the negative battery cable.

8.

After installing the Seat Belt Pretensioner (BPT), confirm proper system operation:

A.

Turn the ignition switch ON; the SRS indicator light should blink for about six seconds and then go off.

Яндекс.Метрика