Component Inspection
1.

Check IATS resistance

(1)

IG "OFF".

(2)

Disconnect IATS connector.

(3)

Measure resistance between terminal 3 and 4 of IATS connector(Component Side)

a.

Specification :

Temp. (℃)

-40.0

-20.0

0.0

20.0

40.0

60.0

80.0

Temp. (°F)

-40.0

-4.0

32.0

68.0

104.0

140.0

176.0

Resist. (㏀)

40.93~48.35

13.89~16.03

5.38~6.09

2.31~2.57

1.08~1.20

0.54~0.62

0.29~0.34

(4)

Is the measured resistance within specification ?

YES

a.

Go to "Check ECM" as follows.

NO

a.

Substitute with a known - good IATS and check for proper operation.

If the problem is corrected, replace IATS and go to "Verification of Vehicle Repair" procedure.

2.

Check ECM

(1)

IG "OFF" and disconnect MAFS/MAPS connector.

(2)

Connect scantool and Key "ON".

(3)

Select simulation function on scantool.

(4)

Simulate voltage at terminal 3 of IATS signal connector.

(5)

Does the signal value of IATS change according to simulation voltage ?

YES

a.

Thoroughly check connectors for looseness, poor connection, bending, corrosion,contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of Vehicle Repair" procedure.

NO

a.

Substitute with a known - good ECM and check for proper operation.

If the problem is corrected, replace ECM and go to "Verification of Vehicle Repair" procedure.

Яндекс.Метрика