4.
Perform the "STALL TEST" with gear position "1"
a.
Specification : INPUT SPEED - (OUTPUT SPEED × GEAR RATIO) ≤ 200 RPM
Connect scantool to data link connector(DLC)
Engine "ON".
Monitor the "ENGINE SPEED, INPUT SPEED SENSOR, OUTPUT SPEED SENSOR, GEAR POSITION" parameter on the scantool
Perform the "STALL TEST" with gear position "1"
Specification : INPUT SPEED - (OUTPUT SPEED × GEAR RATIO) ≤ 200 RPM
Are "INPUT & OUTPUT SPEED SENSOR" within specifications?
YES
Go to "Component Inspection" procedure
NO
Check for electrical niose of circuit in INPUT & OUTPUT SPEED SENSOR or Replace INPUT & OUTPUT SPEED SENSOR. Repair as necessary and Go to "Verification Vehicle Repair" procedure
