1.
Remove 4 screws and 2 clips holding the tailgate trim panel.
Remove 4 screws and 2 clips holding the tailgate trim panel.
Remove the rear wiper arm after removing a nut.
Tightening torque
10~13 Nm (100~130 kg·cm, 7.3~9.5 lb·ft)
Remove a hexagonal nut after removing a pivot cover.
When installing cap & pad, the arrow mark should be indicated upward.
Tightening torque
10~14 Nm (100~140 kg·cm, 7.3~10.2 lb·ft)
Remove the rear wiper motor after removing 2 bolts and disconnect the wire connector.
Tightening torque
7~11 Nm (70~110 kg·cm, 5.1~8.0 lb·ft)
Installation is the reverse of removal.
Install the rear wiper arm and blade to the specified position.
Specified position | A |
Distance | 43~53 mm |
Set the rear washer nozzle on the specified spray position.
Remove the connector from the rear wiper motor.
Connect battery positive (+) and negative (-) cables to terminals 3 and 4 respectively.
Check that the motor operates normally. Replace the motor if it operates abnormally.
