Component Location
General Description

The rear heated oxygen sensor is mounted on the rear side of the Catalytic Converter (warm-up catalytic converter) or in the rear exhaust pipe, which is able to detect catalyst efficiency. The rear heated oxygen sensor (HO2S) produces a voltage between 0V and 1V. This rear heated oxygen sensor is used to estimate the oxygen storage capability. If a catalyst has good conversion properties, the oxygen fluctuations are smoothed by the oxygen storage capacity of the catalyst. If the conversion provided by the catalyst is low due to aging, poisoning or misfiring, then the oxygen fluctuations are similar to signals from the front oxygen sensor.

DTC Description

Checking output signals from HO2S under detecting condition, if an output signal is below 0.04V for more than predeterminate time, PCM sets P0157. MIL(Malfunction Indication Lamp) turns on when the malfunction lasts till consecutive 2 driving cycle.

DTC Detecting Condition

Item

Detecting Condition

Possible cause

DTC Strategy

● Monitor signal voltage

● Poor Connection

● Short to ground in harness

● HO2S(B2/S2)

● PCM

Enable Conditions

● Battery voltage ≥ 10V

● Engine running ≥ 60 sec.

● Engine warm-up state

Threshold value

● The voltage of HO2S(B2/S2) < 0.04V

Diagnosis Time

● Continuous (more than 12.5 sec. failure for every 15 sec.test)

MIL On Condition

● 2 Driving Cycles

Specification
Reference only

Test Condition

HO2S Voltage(Sensor1)

HO2S Voltage(Sensor2)

HO2S Signal at idle after warm-up

Signal is commonly switching from rich to lean more than 3 times in 10 sec.

Signal is commonly above 0.6V.

HO2S signal at open circuit (Pumping current OFF)

Approx. 0.45V

HO2S signal at open circuit(Pumping current ON)

Approx. 3.5V

Schematic Diagram
note
To view Flash content, you need to install the appropriate browser extension
note
To view Flash content, you need to install the appropriate browser extension
Signal Waveform

After warming-up, if accelerator pedal is released suddenly around 4000rpm, the HO2S signal reading will be lower than 200mV resulting from Fuel cut-off for the moment. Conversely, if suddenly accelerator pedal is depressed, HO2S signal reading will be around 0.6V ~1.0V. At idle, Normally HO2S signal will switch from lean to rich with 3 Hz. And as racing, Its frequency rises.

Яндекс.Метрика