1.
Apply gear oil on the drive shaft spliness(A) and the contacting surface of differential case oil seal(B).
Replace the circlip with new ones after removal.
Apply gear oil on the drive shaft spliness(A) and the contacting surface of differential case oil seal(B).
After installation, check if the drive shaft cannot be removed.
[RH]
Install the inner shaft bracket mounting bolt(A).
Tightening Torque Nm(kgf·m, lb-ft) :
50 ~ 65(5 ~ 6.5, 36 ~ 47)
Install the inner shaft cover(A) by installing the cover mounting bolts(B).
Tightening Torque Nm(kgf·m, lb-ft) :
9 ~ 14(0.9 ~ 1.4, 6.5 ~ 10)
Install the front strut assembly(B) to the fork(A).
Tightening Torque Nm(kgf·m, lb-ft) :
60 ~ 80(6 ~ 8, 44 ~ 59)
Install the connecting bolt(A) between the fork and the lower arm.
Tightening Torque Nm(kgf·m, lb-ft) :
140 ~ 160(14 ~ 16, 101 ~ 118)
Install the stabilizer link(A) to the frok(B).
Tightening Torque Nm(kgf·m, lb-ft) :
100 ~ 120(10 ~ 12, 74 ~ 88)
Install the drive shaft into the knuckle.
Be careful not to damage the boot.
Install the knuckle in the lower arm assembly.
Tightening Torque Nm(kgf·m, lb-ft) :
100 ~ 120(10 ~ 12, 74 ~ 88)
Install the tie rod end(A) in the knuckle.
Tightening Torque Nm(kgf·m, lb-ft) :
24 ~ 34(2.4 ~ 3.4, 18 ~ 25)
Install the wheel speed sensor in the knuckle.
Install the brake hose bracket mounting bolt(A) to the front knuckle.
After installing the washer(B) with convex surface outward, install the lock nut(A) and the spilt pin(C).
Tightening Torque Nm(kgf·m, lb-ft) :
200~280 (20~28, 148~207)
Install the wheel and tire.
Tighten the components with the tightening torque.
Tightening Torque Nm(kgf·m, lb-ft)
Drivershaft castle nut
200 ~ 280(20 ~ 80, 148 ~ 207)
Lower arm and ball joint
100 ~ 120(10 ~ 12, 74 ~ 88)
Shock absorber lower mounting bolts
140 ~ 160(14 ~ 16, 101 ~ 118)
Tie rod end and knuckle
24 ~ 34(2.4 ~ 3.4, 18 ~ 25)
Replace the retainer ring every time the driveshaft is removed from the transaxle case.
Install the washer on driveshaft and tighten the nut as illustrated.
Install the split pin.
