2.
Remove the parking brake mounting bolt(A) and the wire(B).
Remove the lower panel, after loosening the parking lever (Refer to BD Gr. 'Crash pad')
Remove the parking brake mounting bolt(A) and the wire(B).
Remove the floor console (Refer to BD Gr. 'Console').
Remove the parking brake wire by removing the adjusting nut(A).
Raise the front of the vehicle, and make sure it is securely supported.
Remove the rear wheel and tire from the rear hub.
Remove the caliper assembly from the carrier and suspend it with wire.
Remove the brake disk and the rear axle hub (Refer to DS Gr. 'Rear axle')
While fastening the spring, remove the shoe hold down pin(A) and spring(B).
Remove the adjuster assembly(A) and the lower return spring(B).
Remove the strut assembly(C).
Remove the retaining ring(B) from the parking brake wire(A) which is in the rear side of the backing plate.
Remove the parking brake wire connecting hook(C) from the brake shoe.
Install the brake shoe(A) to the backing plate(B).
Connect the parking brake wire to the brake shoe.
After installing the strut assembly(A), install the adjuster assembly(B) and the lower return spring(C).
While pressing the spring, install the brake shoe hold down pin(A) and spring(B).
Grease where it is necessary.
Install the rear axle hub(A) and the brake disk(Refer to DS Gr. 'Rear axle').
Install the rear wheel and tire to the rear hub.
Tighten the parking brake adjusting nut.
Install the floor console (Refer to BD Gr. 'Console').
Install the parking brake mounting bolt(A) and the wire(B).
Raise the front of the vehicle, and make sure it is securely supported.
Remove the rear wheel and tire from the rear hub.
After removing the plug from the disk, rotate the toothed wheel by a screw driver until the disk is not moving, and then return it by 5 notches.
Adjust the adjusting nut(A) so that parking pedal stoke is to be 88 ~ 98 mm(3.46 ~ 3.86 in) when operating effort is 200 N(20 kgf, 44 lb) after full stroke operation of parking pedal over 3 times for setting parking wire.
The parking brake adjustment must be carried out after adjusting the rear shoe.
After adjusting parking brake, notice following matter;
Must be free from clearance between adjusting nut and pin. Check securely that the bake is not dragging |
While operating the parking brake pedal for 100 N(10 kgf, 22 lb) effort, drive the vehicle 500 meters (0.31 miles) at the speed of 60 kph (37.3 mph).
Repeat the above procedure more than two times.
Must be held on at 30% uphill.
After adjusting parking brake, notice following matter;
Must be free from troubles when the parking pedal is operated at 1 kN(100 kgf, 220 lb).
Check that all parts move smoothly.
the parking brake indicator lamp must be on after the parking pedal is worked and must be off after the pedal is released.
