4.
Monitor the "SENSOR ANGLE" Parameter on the Scantool.
a.
Specification : SENSOR ANGLE < 3.88
Park the vehicle in a flat land and remove all the loads from the vehicle
Connect scantool to Data Link Connector(DLC).
Engine "ON" and Head lamp"ON"
Monitor the "SENSOR ANGLE" Parameter on the Scantool.
Specification : SENSOR ANGLE < 3.88
Is parameter displayed within the Specification?
YES
Fault is intermittent caused by faulty ECM or was repaired and DTC in ECM memory was not cleared. Clear the DTC and go to "Verification Vehicle Repair" procedure
NO
Go to "Inspection/Repair" procedure
