5.
Disconnect the SRSCM harness connector(A) and (B) from the SRSCM.
Disconnect the battery negative cable and wait for at least three minutes before begining work.
Remove the ignition key from the vehicle.
Disconnect the DAB, PAB, SAB, CAB,BPT and BUPT connectors.
Remove the front seats, floor console and heater ducts. (Refer to BD group)
Disconnect the SRSCM harness connector(A) and (B) from the SRSCM.
Remove the SRSCM mounting bolts(4EA) from the SRSCM, then remove the SRSCM.
Disconnect the battery negative cable and wait for at least three minutes before begining work.
Remove the ignition key from the vehicle.
Install the SRSCM with the SRSCM mounting bolts.
Tightening torque (SRSCM Mounting Bolt)
: 0.7 ~ 0.9 kgf.m (6.9 ~ 8.8 Nm, 5.1 ~ 6.5 lb.ft)
Connect the SRSCM harness connector.
Install the heater ducts, floor console and front seats. (Refer to BD group)
Connect the DAB, PAB, SAB, CAB,BPT and BUPT connectors.
Reconnect the battery negative cable.
After installing the SRSCM, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
