Remove the wheel and tire.

Disconnect the wheel speed sensor(A) from theknuckle.

Disconnect the brake hose(A) from the knuckle.

Remove the caliper assembly(B) and suspend it with wire.

Remove the split pin(A) and driveshaft castle nut(B) from the front hub.

Remove the 2 bolts(A) and disconnect the ball joint from the knuckle.

Using the special tool (09568-4A000), disconnect the tie rod end from the knuckle.

Using a plastic hammer, disconnect the driveshaft from the axle hub.

Loosen the upper armmounting nut but do not remove it.

Using the special tool (09568-4A000), disconnect the upper arm(A) from the knuckle.

Remove the front axle and knuckle together.

Installation is the reverse of removal.