1.
Detach the clips, then remove the trunk trim (A).
note
-
When removing and installing the trunk lid, an assistant is necessary.
-
Wear gloves to protect hands from injury.
When removing and installing the hood, an assistant is necessary.
Wear gloves to protect hands from injury.
Disconnect the trunk lid connector (A).
Loosn the bolts, then remove the trunk lid (B).
Installation is the reverse of removal.
Make sure the trunk lid opens properly and locks securely.
Adjust the trunk lid alignment.
Detach the clips, then remove the trunk trim (A).
When removing and installing the trunk lid, an assistant is necessary.
Wear gloves to protect hands from injury.
Installation is the reverse of removal.
Replace any damaged clips.
Remove the trunk lid trim.
Disconnect the key cylinder (A), connector (B) and cable (C).
After loosening the mounting bolt, then remove the latch assembly (D).
Installation is the reverse of removal.
Make sure the connector is connected properly and the cylinder rod is connected properly.
Make sure the trunk lid opens properly and locks securely.
Remove the trunk lid trim.
Disconnect the inside handle cable (B) from the latch.
After loosening the inside handle mounting screws, then remove the inside handle (A).
Installation is the reverse of removal.
Make sure the trunk lid latch cable is connected properly.
Make sure the trunk lid opens properly and locks securely.
Remove the trunk lid weatherstrip (A).
Installation is the reverse of removal.
Remove the trunk lid trim.
Remove the trunk lid garnish (A).
Disconnect the outside handle rod (B) and connector (A).
Remove the outside handle (C).
Loosen the key holder mounting bolt and remove (A).
Installation is the reverse of removal.
Using a screwdriver (A), lift up slightly the socket clips (B) of both ends on the lifter (D), and then remove the lifter from the bracket (C).
Loosen the mounting nut, then remove the trunk lid lift (D).
Push the socket of the lifter into the bracket for installation.
Remove the front door trim.
Loosen the mounting screw, then remove the trunk lid open switch (A).
Installation is the reverse of removal.
Loosen the bolts, then remove the fuel filler door (A).
Installation is the reverse of removal.
Make sure the fuel fill door opens properly and locks securely.
Check that the fuel fill door (A) fit flush against the body. If necessary, adjust it.
After loosening the trunk lid hinge (A) mounting bolt, adjust the hood (D) by moving it up or down, or right or left.
Adjust the trunk lid height by turning the trunk lid overslam bumpers (C).
After loosening the trunk lid latch (B) mounting bolts, adjust the trunk lid latch by moving it up or down, or right or left.
