1.
Remove the quadrant inner cover (A).
Take care not to scratch the door trim and other parts.
Put on gloves to protect your hands.
Remove the quadrant inner cover (A).
Remove the inside handle cover (A).
Loosen the door trim (F) mounting screws. Release the clips that hold the door trim, then remove the door trim by pulling it upward. Disconnect the power window switch connector (A), power mirror connector (B), and door courtesy lamp connector (C), trunk lid connector (D).
Installation is the reverse of removal.
Make sure of connectors is plugged in properly and each rod is connected securely.
Make sure the door lock and opens properly.
Remove the front door trim.
Remove the glass mounting hole plug (A).
Using the door switch to align the mounting hole with the hole on the door glass.
If it is impossible, align the hole with hands after removing the motor.
Take care not to drop to glass and scratch the glass surface.
Carefully move the glass (B) until you can see the bolts, then loosen them. Separate the glass from the glass run and carefully pull the glass out through the window slot.
Installation is the reverse of removal.
Roll the glass up down to see if it move freely without binding.
Adjust the position of the glass as necessary
Remove the door trim.
After disconnecting the connector (A), remove the power window motor (B).
Installation is the reverse of removal.
Roll the glass up down to see if it move freely without binding.
Loosen the mounting bolt, then remove the key holder (A).
Remove the outside handle (A).
Installation is the reverse of removal.
Remove the following parts.
Front door trim.
Glass.
Out side handle.
Remove the outside handle pad (A).
Remove the inside handle.
Remove the latch assembly.
Remove the outside support bracket (A).
After disconnecting the cable (A), remove the outside handle base (B).
Installation is the reverse of removal.
Make sure the door lock and open properly.
Remove the following parts.
Front door trim.
Glass.
Inside handle.
Outside handle.
Loosen the door module mounting bolts, then remove the door module (A).
Remove the clips.
Disconnect the door module wiring harness (A), then remove the module assembly (B).
Installation is the reverse of removal.
Make sure the connector is plugged in properly and each rod is connected securely.
Make sure the door lock and open properly.
Remove the front door trim.
Loosen the inside handle (A) mounting screws.
Remove the space (D).
Disconnect the lock cable (A) and inside connect cable (B).
Remove the inside handle (C).
Installation is the reverse of removal.
Make sure the door locks and open properly.
Remove the following parts.
Front door trim.
Glass.
Inside handle.
Out side handle.
Remove the module assembly.
Disconnect the latch connector (A), then remove the latch assembly (B).
Installation is the reverse the removal.
Make sure the door locks and opens properly.
Loosen the mounting screw, then remove the door belt weatherstrip (A).
Installation is the reverse of removal.
Remove the front door trim.
Loosen the mounting screws (A).
Remove the power window switch (A).
Installation is the reverse the removal.
Loosen the checker mounting bolts.
Detach the clips, then remove the weatherstrip (A).
Installation is the reverse of removal.
Remove the front door scuff trim.
Remove the weatherstrip (A).
Installation is the reverse of removal.
