2.
Tighten the transaxle under mounting bolts (A) and the drive plate bolts (B).
TORQUE
[A] : 34.3~41.2 Nm(350~420 Kgf.cm, 25.3~30.4 lb.ft)
[B] : 45.1~52.0 Nm(460~530 Kgf.cm, 33.3~38.3 lb.ft)
Lowering the vehicle or lifting up a jack, install the transaxle assembly.
Tighten the transaxle under mounting bolts (A) and the drive plate bolts (B).
TORQUE
[A] : 34.3~41.2 Nm(350~420 Kgf.cm, 25.3~30.4 lb.ft)
[B] : 45.1~52.0 Nm(460~530 Kgf.cm, 33.3~38.3 lb.ft)
Install the starter motor mounting bolt and nut. (refer to EE group)
Install drive shaft(A, B) from transaxle. (refer to DS group).
Supporting the cross member with the SST(09624-38000), tighten the steering column bolt and the cross member (A) mounting bolts. (refer to ST group)
Install the muffler hanger rubber.
Install the front and rear roll stopper mounting bolts.
Install the front exhaust pipe. (refer to EM group)
Install the steering bar tie rod, the stabilizer bar link and the lower arm assembly. (refer to ST group)
Connect the the power steering return hose by tightening the clamp (A).
Install the front wheels and Lifting up the vehicle, remove the under cover (A).
Connect the power steering pressure bolt. (refer to ST group)
Remove the SST(09200-38001) holding the engine and transaxle assembly.
After lowering the vehicle, tighten the transaxle insulator mounting bolt (A).
TORQUE :
65~85 Nm(6.5~8.5 kgf.m, 47.0~61.5 lb-ft)
Install the transaxle upper mounting bolts (A).
TORQUE : 65~85 Nm(6.5~8.5 kgf.m, 47.0~61.5 lb-ft)
Install the vehicle speed sensor connector (B) and output speed sensor connector (A).
Install the inhibitor switch connector (A), solenoid valve connector (B) and the input shaft speed sensor connector (C).
Install the ground earth wire (A).
Install the transaxle oil cooler hoses (A) releasing the clamps.
Install the battery tray (A).
Install the PCM connector (B) and air cleaner under body (A).
Install the AFS connector (A) and air cleaner upper body (B).
Install the battery (A).
Install the engine cover (A).
Refill the automatic transaxle fluid. (refer to 'SERVICE ADJUSTMENT PROCEDURE')
Refill the power steering fluid and bleed the air. (refer to ST group)
