4.
Loosen the SAB mounting nuts and remove the SAB module.
warning
The removed airbag module should be stored in a clean and dry place with the cushion side up.
Disconnect the battery negative cable and wait for at least 3 minutes before beginning work.
Remove the front seat assembly.(Refer to BD group)
Remove the seat-back cover.(Refer to BD group)
Loosen the SAB mounting nuts and remove the SAB module.
The removed airbag module should be stored in a clean and dry place with the cushion side up.
Disconnect the battery negative cable and wait for at least 3 minutes before begining work.
Remove the rear seat cushion. (Refer to BD group)
Loosen the rear side airbag assembly mounting bolt(1EA).
Disconnect the rear side airbag assembly connector, then remove the rear side airbag assembly.
Remove the rear side airbag assembly cover.
Loosen the rear side airbag module mounting nuts and remove the airbag module.
The removed airbag module should be stored in a clean and dry place with the cushion side up.
Be sure to install the harness wires not to be pinched or interfered with other parts.
Do not open the lid of the side airbag cover.
Use a new mounting nuts when you replace a side airbag.
Make sure that the airbag assembly cover is installed properly. Improper installation may prevent the proper deployment.
Disconnect the battery negative cable and wait for at least three minutes.
Remove the ignition key from the vehicle.
Place a Side Airbag (SAB) on the side airbag frame and tighten the side airbag mounting nuts(2EA).
Tightening torque
: 0.7 ~ 0.9 kgf.m (7.0 ~ 9.0 Nm, 5.2 ~ 6.6 lb.ft)
Install the new seat-back cover.(Refer to BD group)
Install the front seat assembly, then connect the Side Airbag (SAB) harness connector.
Recline and slide the front seat forward fully, make sure the harness wires are not pinched of interfering with other parts.
Reconnect the battery negative cable.
After installing the Side Airbag (SAB), confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Be sure to install the harness wires not to be pinched or interfered with other parts.
Do not open the lid of the side airbag cover.
Use a new mounting nuts when you replace a side airbag.
Make sure that the airbag assembly cover is installed properly. Improper installation may prevent the proper deployment.
Disconnect the battery negative cable and wait for at least three minutes.
Remove the ignition key from the vehicle.
Place a Side Airbag (SAB) on the side airbag frame and tighten the side airbag mounting nuts(2EA).
Tightening torque
: 0.7 ~ 0.9 kgf.m (7.0 ~ 9.0 Nm, 5.2 ~ 6.6 lb.ft)
Install the new rear side airbag assembly cover.(Refer to BD group)
Connect the Side Airbag (SAB) harness connector, then install the rear side airbag assembly.
Tightening torque
: 1.7 ~ 2.6 kgf.m (16.7 ~ 25.5 Nm, 12.3 ~ 18.8 lb.ft)
Reconnect the battery negative cable.
After installing the Side Airbag (SAB), confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
