3.
Loosen the Seat Belt Buckle Pretensioner mounting bolt(A) and remove the Seat Belt Buckle Pretensioner.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
Remove the front seat assembly. (Refer to BD group)
Loosen the Seat Belt Buckle Pretensioner mounting bolt(A) and remove the Seat Belt Buckle Pretensioner.
Disconnect the battery negative cable and wait for at least three minutes.
Remove the ignition key from the vehicle.
Install the Seat Belt Buckle Pretensioner (BUPT) with the bolt.
Tightening torque
: 4.0 ~ 5.5 kgf.m (39.2 ~ 53.9 Nm, 28.9 ~ 39.8 lb.ft)
Install the front seat assembly.
Be sure to install the harness wires not to be pinched or inrerfered with other parts.
Reconnect the battery negative cable.
After installing the Seat Belt Buckle Pretensioner (BUPT), confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
