1.
Install the water pump(A) and a new gasket(B) with the bolts.
Tightening torque
14.7 ~ 21.6Nm (1.5 ~ 2.2kgf.m, 10.8 ~ 15.9lb-ft)
note
Clean the contacting face before assembling.
Install the water pump(A) and a new gasket(B) with the bolts.
Tightening torque
14.7 ~ 21.6Nm (1.5 ~ 2.2kgf.m, 10.8 ~ 15.9lb-ft)
Clean the contacting face before assembling.
Install the drive belt(A).
After inserting the drive belt between engine support bracket and power steering pump (or idle pulley), install the drive belt as above and install the tensioner arm applying force to counter-clockwise with a wrench)
Install the engine support bracket(A).
Tightening torque :
58.8 ~ 68.6 Nm (6.0 ~ 7.0 kgf.m, 43.4 ~ 50.6Ib-ft)
After the removal, engine coolant can bo drained a little from that point(B) which is a matter of on importance.
Over-torque can damage thread of cylinder block.
Be care the difference of upper 2 botls and lower 1 bolt lenght.
Install drive belt(A).
Fill with engine coolant.
Start engine and check for leaks.
Recheck engine coolant level.
Install the water pipe(A).
Tightening torque
16.7 ~ 19.6Nm (1.7 ~ 2.0kgf.m, 12.3 ~ 14.5lb-ft)
Install the water temperature control assembly(A) with a new gasket(B).
Tightening torque
29.4 ~ 41.2Nm(3.0 ~ 4.2kgf.m, 21.7 ~ 30.4lb-ft
Use new O-rings and wet them with water or coolant when reassembling.
Install the wiring protector.
Connect the heater hose and ECT hose.
Connect the ECT sensor connector.
Connect the radiator upper and the lower hose(A).
Install the air cleaner assembly.
Fill with engine coolant.
Start engine and check for leaks.
Recheck engine coolant level.
