IG "OFF" & connect scantool.

ENG "ON" and warm -up the engine to normal operating temperature.

Monitor "CAM(B2)" status on the service data.

Are the "CMP(B2)" data displayed correctly ?

YES

▶ Fault is intermittent caused by poor contact in the sensor’s and/or PCM’s connector or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poorconnection, ending, corrosion, contamination, deterioration, or damage. Repair or replace asnecessary and go to "Verification of Vehicle Repair" procedure

NO

▶ Go to "Terminal and connector inspection" procedure