Monitor DTC Status
1.

Ignition "OFF"

2.

Connect Scantool and Engine "ON"

3.

Check whether steering pressure is rising during operating. (Keep the idling status)

Fig1) Data with not turning steering wheel at idle

Fig2) Data with turning steering wheel at idle

4.

Is the current data displayed correctly ?

YES

a.

Fault is intermittent caused by poor contact in Sensor’s and/or PCM’s connector or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of Vehicle Repair" procedure

NO

a.

Go to "W/Harness Inspection" procedure.

Яндекс.Метрика