Component Location
General Description

To make system be more efficient, Body Control Module(hereinafter referred to BCM) applies CAN(Controller Area Network) communication system. CAN is a kind of communication system which can make related component share system information with just two line instead of complex individual signal line. It consists of related component and CAN BUS which consists of CAN_high line and CAN_low line. Each component can send and receive information by binary signal via CAN BUS. The related components for BCM are BCM, ADM, DDM, I/F ECU and IMS(Seat, S/C), Multifunction switch connect with BCM by LIN communication line and delivers input signal made by driver to BCM

DTC Description

The ECM sets DTC B1630 if there’s any fault in data signal transmitted to multifunction switch

DTC Detecting Condition

Item

Detecting Condition

Possible Cause

DTC Strategy

-

● Faulty multifunction s/w

● Open/Short circuit in signal harness

● Faulty BCM

● Open/Short circuit in BCM Power harness

Enable Conditions

-

Threshold value

-

Detecting time

-

FAIL SAFE

-

Schematic Diagram
note
To view Flash content, you need to install the appropriate browser extension
Signal Waveform
Яндекс.Метрика