3.
Has a problem been found?
YES
a.
Repair as necessary and go to "Verification Vehicle Repair" procedure
NO
a.
Go to "Component Inspection" procedure
Many malfunctions in the electrical system are caused by poor harness and terminals.
Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
Has a problem been found?
YES
Repair as necessary and go to "Verification Vehicle Repair" procedure
NO
Go to "Component Inspection" procedure
Ignition "OFF"
Disconnect tilt motor.
Measure resistance between terminal "8" of Tilt/Telescope ECU and terminal "10" of tilt sensor.
Measure resistance between terminal "9" of Tilt/Telescope ECU and terminal "6" of tilt sensor.
Specification :Approx. 0 Ω
Is the measured resistance within specifications?
YES
Go to "Check for short in harness" procedure.
NO
Check for open in signal harness. Repair as necessary and go to "Verification of Vehicle Repair" procedure.
Ignition "OFF"
Disconnect tilt motor.
Measure resistance between terminal "6" and "10" of tilt sensor and chassis ground
Specification :Approx. ∞ Ω
Is the measured resistance within specifications?
YES
Go to "Power circuit Inspection" procedure.
NO
Check for short in signal harness. Repair as necessary and go to "Verification of Vehicle Repair" procedure.
1) Check for open in harness
Ignition "OFF"
Disconnect tilt motor.
Measure resistance between terminal "2" of Tilt/Telescope ECU and terminal "4" of tilt motor.
Measure resistance between terminal "3" of Tilt/Telescope ECU and terminal "5" of tilt motor.
Specification :Approx. 0 Ω
Is the measured resistance within specifications?
YES
Go to "Check for short in harness" procedure.
NO
Check for open in motor power harness. Repair as necessary and go to "Verification of Vehicle Repair" procedure.
2) Check for short in harness
Ignition "OFF"
Disconnect tilt motor.
Measure resistance between terminal "4" of tilt motor and chassis ground
Measure resistance between terminal "5" of tilt motor and chassis ground
Specification :Approx. ∞ Ω
Is the measured resistance within specifications?
YES
Go to "Sensor Power circuit Inspection" procedure.
NO
Check for short in power harness. Repair as necessary and go to "Verification of Vehicle Repair" procedure.
Ignition "OFF"
Disconnect tilt motor.
Measure voltage between terminal "11" of tilt motor and chassis ground
Specification : Approx. 5V
Is the measured voltage within specifications?
YES
Go to "Ground circuit Inspection" procedure.
NO
Check for open or short in harness. Repair as necessary and go to "Verification of Vehicle Repair" procedure.
Ignition "OFF"
Disconnect tilt motor.
Measure resistance between terminal "9" of tilt motor and chassis ground
Specification :Approx. 0 Ω
Is the measured resistance within specifications?
YES
Go to "Component Inspection " procedure.
NO
Check for open in ground harness. Repair as necessary and go to "Verification of Vehicle Repair" procedure.
