3.
Monitor the "DR. MIRROR RIGHT(LEFT) SW " Parameter on the Scantool. While operating left outside mirror switch.
a.
Specification : Refer the specifications in fig2)
Connect scantool to Data Link Connector(DLC).
Ignition "ON" & engine "OFF"
Monitor the "DR. MIRROR RIGHT(LEFT) SW " Parameter on the Scantool. While operating left outside mirror switch.
Specification : Refer the specifications in fig2)
Is the measured current data within specifications?
YES
Go to " Check left outside mirror motor" procedure.
NO
Substitute with a known-good DDM and check for proper operation.
If the problem is corrected, replace DDM and then go to "Verification of Vehicle Repair" procedure.
Connect scantool to Data Link Connector(DLC).
Ignition "ON" & engine "OFF".
Select ‘ACTUATION TEST’ mode on scantool and press [F1] to start.
Dose left outside mirror motor work properly?
YES
Go to " Check left outside mirror sensor" procedure.
NO
Substitute with a known-good left outside mirror and check for proper operation.
If the problem is corrected, replace left outside mirror and then go to "Verification of Vehicle Repair" procedure.
Connect scantool to Data Link Connector(DLC).
Ignition "ON" & engine "OFF".
Monitor the "MIRROR HORI. POS" Parameter on the Scantool. While operating left outside mirror switch.
Specification : The furthest left → Approx. 1.0V,
The furthest right → Approx. 3.5V
Is the measured voltage within specifications in fig5)?
YES
Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.
NO
Substitute with a known-good left outside mirror and check for proper operation.
If the problem is corrected, replace left outside mirror and then go to "Verification of Vehicle Repair" procedure.
