Component Inspection
■ Check EOTS resistance
1.

IG "OFF" and disconnect ECTS connector.

2.

Measure resistance between signal and ground terminals of EOTS connector after checking out the temperature of EOTS with scantool.(Component Side)

Specification :

Temp. (℃)

Resistance (kΩ)

Temp. (℃)

Resistance (kΩ)

-40

48.14

40

1.15

-20

14.13 ~ 16.83

60

0.59

0

5.79

80

0.32

20

2.31 ~ 2.59
3.

Is the measured resistance within specification ?

▶ Clear DTC and Test-drive under enable conditions above-mentioned. After the test, If this DTC is set, recheck it thoroughly. If not, it is intermittent fault, go to "Verification of vehicle Repair" procedure.

▶ Substitute with a known - good ECTS and check for proper operation. If the problem is corrected, Go to "Verification of Vehicle Repair"procedure.

Яндекс.Метрика