Check HO2S(B1/S1) Heater resistance
IG "OFF" and disconnect HO2S(B1/S1) connector
Measure resistance between terminal 3 and 4 of HO2S(B1/S1)(Component Side)
Specification :
Heater | |
Resistance (Ω) | 3.0~4.0Ω[21℃(69.8℉)] |
Is the measured resistance within specification ?
YES
▶ Substitute with a known - good PCM and check for proper operationure.
If the problem is corrected, go to "Verification of Vehicle Repair" procedure.
There is a memory reset function on scantool that can erase optional parts automatically detected and memorized by PCM. Before or after testing PCM on the vehicle, use this function to reuse the PCM on the others
NO
▶ Substitute with a known - good HO2S(B1/S1) and check for proper operation.
If the problem is corrected, go to "Verification of Vehicle Repair" procedure.
