4.
Change a shift lever from P-range to D-range.
Fig 1) P range
Fig 2) R range
Fig 3) N range
Fig 4) D range
Connect GDS to Data Link Connector(DLC).
Ignition "ON" & engine "OFF".
Selet "Currnet Data"mode and monitor "Inhibitor switch" parameter.
Change a shift lever from P-range to D-range.
Fig 1) P range
Fig 2) R range
Fig 3) N range
Fig 4) D range
Is the Inhibitor switch value chaged in specification?
 | ▶ Fault is intermittent caused by poor contact of PCM/TCM and DTC was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair as necessary and go to "Verification Vehicle Repair" procedure. |
 | ▶ Go to "Terminal and Connector Inspection" procedure. |
