3805164

1.

IG "OFF" and disconnect ignition coil connector.

2.

Measure resistance between power and signal terminals of ignition coil connector.(Measurement "A")

3.

Measure resistance between power terminal of ignition coil connector and out terminal of secondary ignition coil.(Measurement "B")

Specification :

Resistance(Ω)	Primary Coil	Secondary Coil
Resistance(Ω)	0.62 ± 10% (20℃)	7.0k ± 15% (20℃)

4.

Is the measured resistance within specification?

	▶ Substitute with a known - good ECM and check for proper operation. If the problem is corrected, replace ECM and go to "Verification of Vehicle Repair" procedure. note There is a memory reset function on scantool that can erase optional parts automaticallydetected and memorized by ECM.Before or after testing ECM on the vehicle, use this function to reuse the ECM on the others
	▶ Substitute with a known - good Ignition Coil and check for proper operation. If the problem is corrected, replace Ignition Coil and go to "Verification of Vehicle Repair" procedure.