Disconnect the negative (-) battery terminal.

Remove the front bumper.

(Refer to the BD group - "Front bumper")

Replace the bulb (B) by rotating the bulb holder to the clockwise direction after disconnecting the fog lamp connector (A).

Remove the front fog lamp assembly (A) after loosening nuts and disconnecting the fog lamp connector.

Installation is the reverse of removal.

Pull out the front fog lamp (A) relay from the engine compartment relay box.

Check for continuity between terminals. There should be continuity between the No.1 and No.2 terminals when power and ground are connected to the No.3 and No.4 terminals.

There should be no continuity between the No.1 and No.2 terminals when power is disconnected.