3.
Disconnect the CVVT oil control valve connector (A).
Turn the ignition switch OFF.
Disconnect the OCV connector.
Measure resistance between the OCV terminals 1 and 2.
Check that the resistance is within the specification.
Specification: Refer to “Specification”
Turn ignition switch OFF and disconnect the negative (-) battery cable.
Remove the intake manifold (Refer to “Intake And Exhaust System” in EM group).
Disconnect the CVVT oil control valve connector (A).
Remove the mounting bolt (B), and then remove the valve from the engine.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
Disconnect the CVVT oil control valve connector (A).
Remove the cylinder head cover (Refer to “Cylinder Head Assembly” in EM group).
Remove the mounting bolt (A), and then remove the valve from the engine.
Installation is reverse of removal.
CVVT oil control valve installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lbf.ft)
Pay attention to color of valve connector (Component and harness side) when installing. If an OCV is installed on opposite bank, the engine may be damaged.
Item | Component Side | Harness Side |
Bank1 (RH) | Grey | |
Bank 2(LH) | Black | |
