2.
After loosening the seat assembly mounting bolts and nuts, remove the seat assembly (B).
Remove the seat assembly mounting cover (A).
After loosening the seat assembly mounting bolts and nuts, remove the seat assembly (B).
Disconnect the connector (C), and remove the seat assembly.
Installation is the reverse of removal.
SEAT MOUNTING BOLT INSTALLATION PROCEDURE
Set the into the most rearward position.
Check then each slide is locked, and then Tighten the front mounting bolt temporarily.
Set the seat into most forward position.
Check that each slide is locked, and then Tighten the rear mounting bolt completely.
Set the seat into the most rearward position.
Check the front mounting bolt completely.
Check that the seat operates to and fro smoothy and the locking portion locks properly.
Remove the cover (A).
Loosen the recliner mounting screw and clip, then remove the recliner cover (A).
Remove the front seat buckle.
Loosen the mounting screw, then remove the cover (A).
Installation is the reverse of removal.
Remove front seat assembly.
Remove the recliner cover.
After disconnecting the scuff band (A), remove the seat back panel (B).
Disconnect the protector (A) from the back frame
Disconnect the connector (B).
Loosen the mounting bolts, then remove the seat back assembly (A).
Remove the headrest and headrest guide (A).
Disconnect the aplix (A) on the front of seat back, remove the back cover (B).
Installation is the reverse of removal.
Remove front seat assembly.
Remove the recliner cover.
Disconnect the connector (A).
Disconnect the protector (A).
Disconnect the aplix (A) on the front of seat cushion and remove the seat cushion cover (B).
Installation is the reverse of removal.
Remove the following items.
Recliner cover.
Seat back panel.
Headrest guide.
Seat back cover.
Remove the pad (A) from frame (B).
Remove the side air bag for replacing side air bag installation seat.
Be fore service, be fully aware of precautions and service procedure relevant to air bag
Installation is the reverse of removal.
Remove the recliner cover.
Remove the seat cushion cover.
Remove the track (B).
- Remove the PODS(A).
Installation is the reverse of removal.
Remove the seat back cover.
Cut the heater (A) attached to the pad (B), as shown in the picture.
Take off the paper from the backside of the heater assembly.
Attach the heater to the main part of pad.
Install the seat back cover.
Remove the seat back cover.
Cut the heater (A) attached to the pad (B), as shown in the picture.
Take off the paper from the backside of the heater assembly.
Attach the heater to the main part of pad.
Install the seat back cover.
