Connect a scantool on the Data Link Connector (DLC).
Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T.
Throttle Angle | Output Voltage (V) | |
TPS 1 | TPS 2 | |
C.T | 0.25 ~ 0.9 | Min.4.0 |
W.O.T | Min.4.0 | 0.25 ~ 0.9 |
Turn the ignition switch OFF and disconnect the scantool from the DLC.
Disconnect the ETC module connector and measure the resistance between the ETC module terminals 4 and 1 (TPS 1).
Specification: Refer to “Specification”
Measure resistance between the ETC module terminals 7 and 6 (TPS 2).
Specification: Refer to “Specification”
Turn the ignition switch OFF.
Disconnect the ETC module connector.
Measure resistance between the ETC module terminals 5 and 8.
Check that the resistance is within the specification.
Specification: Refer to “Specification”
