Be sure to install the harness wire not to be pinched or interfere with other parts.
Do not turn the ignition switch ON and do not contact the battery cable while replacing the front impact sensor.
Install the new Front Impact Sensor with the bolt then connect the SRS harness connector to the Front Impact Sensor.
Tightening torque
: 0.9 ~ 1.2 kgf.m (8.5 ~ 11.5 Nm, 6.3 ~ 8.5 lb.ft)
Install the intake air duct.(for LH FIS)
Reconnect the battery negative cable.
After installing the Front Impact Sensor, confirm proper system operation: Turn the ignition switch ON the SRS indicator light should be turned on for about six seconds and then go off.
