Connect GDS to Data Link Connector(DLC).

Engine "ON" and Head lamp"ON".

Clear the DTC.

Ignition "OFF"

Engine "ON" and Head lamp"ON"

Connect GDS and selet "Diagnostic Trouble Codes(DTCs)" mode and Read "DTC Status" parameter.

	▶ Substitute with a known - good ECU and check for proper operation. If the problem is corrected, replace ECU and go to "Verification of Vehicle Repair" procedure.
	▶ Fault is intermittent caused by poor contact in the sensor’s and/or ECU’s connector or was repaired and ECU memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of vehicle Repair" procedure.

Park at lever land

Vehicle speed ≤ 5km/h

Engine r.p.m > 500rpm

Connect GDS

CAN comm

① Parameter Download

Fig.1) Select the Parameter Download

Fig.2) Parameter Download

Fig.3) Parameter Download - LHD & Manual Gear Suspension 1st

Fig.4) Parameter Download - RHD & Manual Gear

Fig.5) Parameter Download - LHD & Auto Gear

Fig.6) Parameter Download - RHD & Auto Gear

② Calibration

Fig.7) Select the Calibration

Fig.8) Calibration