3.
Check Smart Key ECM/PCM status parameter if DTC is retrieved.
Fig.1) It shows that 2(two) FOB key is registered, Smart Key ECM/PCM is learnt status.
IG KEY "ON" & Engine "OFF".
Erase DTC after connecting GDS.
Check Smart Key ECM/PCM status parameter if DTC is retrieved.
Fig.1) It shows that 2(two) FOB key is registered, Smart Key ECM/PCM is learnt status.
Is the smart Key ECM/PCM learnt ?
 | ▶ Fault is intermittent caused by poor contact in Smart key ECM/PCM and/ or ECM/PCM's connector or was repaired and Smart key ECM/PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure. |
 | ▶ Go to "Wire Harness Inspection" procedure. |
