10651072

1.

Ignition "ON"& Engine "OFF"

2.

Connect scantool to Data Link Connector (DLC).

3.

Select "DTC Analysis" mode.

4.

After erase DTC, keep the vehicle condition within "the enable conditions"

(Refer to "DTC Detecting Condition" table)

5.

Is the same DTC occurred again?

▶ Substitute with a known-good SPAS ECU and check for proper operation.

If problem is corrected, replace SPAS ECU and then go to "Verification of Vehicle Repair" procedure.

* When replace SPAS ECU, must do Variant Coding.(Please refer to C1702 DTC)

▶ Fault is intermittent caused by poor connection in SPAS ECU's connector or was repaired and SPAS ECU memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.