Component Inspection
■ Check STOP LAMP SWITCH
1.

Ignition "OFF".

2.

Disconnect Stop Lamp Switch harness connector.

3.

Measure resistance between Power and Signal NO terminals of Stop Lamp Switch. (Component Side)

4.

Measure resistance between Power and Signal NC terminals of Stop Lamp Switch. (Component Side)

Specification : Measure 1 : Infinity

Measure 2 : below 1Ω.

5.

Is the measured Valule within specification?

▶ Check for poor connection between Stop Lamp Switch and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "Verification of Vehicle Repair" procedure.

▶ Substitute with a known-good Stop Lamp Switch and check for proper operation. If the problem is corrected, replace Stop Lamp Switch and then go to "Verification of Vehicle Repair" procedure.

Яндекс.Метрика