Ignition "OFF".

Disconnect CMPS #2 sensor connector.

Ignition "ON" & Engine "OFF".

Measure voltage between power terminal of CMPS #2 harness connector and chassis ground.

Is voltage within the specification ?

	▶ Go to "Ground Circuit Inspection" procedure.
	▶ Check for a open in the power supply circuit between the main relay and the CMPS. Especially check for open or blown 10A sensor fuse. Repair as necessary and go to "Verification of Vehicle Repair" procedure.

Ignition "OFF".

Measure resistance between ground terminal of CMPS #2 harness connector and chassis ground.

Is resistance within the specification ?

	▶ Go to "Signal Circuit Inspection" procedure.
	▶ Check for an open or short to battery in the ground circuit. Repair as necessary and go to "Verification of Vehicle Repair" procedure.

Check for short to ground in signal harness.

(2)

Is resistance within the specification ?

	▶ Go to next step as below.
	▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure.

Check for short to battery in signal harness.

(4)

Is voltage within the specification ?

	▶ Go to next step as below.
	▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure.

Check for open in signal harness.

(3)

Is resistance within the specification ?

	▶ Go to next step as below.
	▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure.

Many malfunctions in the electrical system are caused by poor harness(es) and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.

Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

Has a problem been found ?

	▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure.
	▶ Go to next step as below.