10679433

Component Inspection

Ignition "OFF".

Disconnect oil control valve connector.

Measure resistance between power terminal and control terminal of the solenoid connector(Component side).

Specification

Oil Control Valve	Normal Parameter At 20℃ (68℉)
Insulation Resistance	9.9±0.5Ω

Is resistance within specification ?

	▶ Go to next step as below.
	▶ Check oil control valve for contamination, deterioration, or damage. Substitute with a known-good solenoid and check for proper operation. If the problem is corrected, replace solenoid and then go to "Verification of Vehicle Repair" procedure.