Component Inspection
1.

IG KEY OFF.

2.

Disconnect VIS Sol. Valve harness connector.

3.

Measure resistance between power terminal and control terminal of VIS Sol. Valve connector. (Component side)

Specification

Temp.

VIS Sol. Valve resist

22℃ (72℉)

30 ~ 35Ω

4.

Is resistance within specification?

▶ Check for poor connection between PCM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "Verification of Vehicle Repair" procedure.

▶ Substitute with a known-good component and check for proper operation. If the problem is corrected, replace component and then go to "Verification of Vehicle Repair" procedure.

Яндекс.Метрика