Engine Coolant Temperature Sensor(ECTS), installed in coolant line, senses engine coolant temperature.
With the information about engine coolant temperature, ECM performs fuel injection quantity correction, cooling fan control and glow relay operating duration control.
Especially, because ECTS signal is main variable of fuel injection quantity correction when engine is cold, sensor trouble makes starting engine difficult when engine is cold.
If engine is running when ECTS is out of order, ECM regards engine coolant temperature as 80°C. And during cranking, ECM considers engine coolant temperature as -10°C. Besides, cooling fan, which is controlled based on ECTS signal, operates at HIGH-MODE to prevent engine overheat and supplementary heater is deactivated.
P0117 is set when the voltage below 200mV - minimum output voltage of ECTS - is detected for more than 2.0 sec. This code is due to short to ground in signal circuit.
Item | Detecting Condition | Possible Cause | ||
DTC Strategy |
•
Voltage monitoring |
•
ECTS circuit
•
ECTS component | ||
Enable Conditions |
•
IG KEY "ON" | |||
Threshold Value |
•
Output signal below the minimum value.( below 200mV ) | |||
Diagnostic Time |
•
2.0 sec. | |||
Fail Safe | Fuel cut | NO |
•
During engine operation : temperature is fixed at 80℃ at cranking : temperature is fixed at -10℃ | |
EGR Off | YES | |||
Fuel Limit | NO | |||
Check Lamp | NO | |||
Temperature | - 40℃ | - 20℃ | 0℃ | 20℃ | 40℃ |
Resistance | 48.14㏀ | 15.48±1.35㏀ | 5.790㏀ | 2.45±0.14㏀ | 1.148㏀ |
Temperature | 60℃ | 80℃ | 100℃ | 110℃ | 120℃ |
Resistance | 0.586㏀ | 0.322㏀ | 0.188㏀ | 0.147±0.002㏀ | 0.116㏀ |
