4.
Are resistances for each terminal measured correctly?
 | ▶ Go to "Verification of Vehicle Rapair". |
 | ▶ Replace APS and go to "Verification of Vehicle Rapair". |
IG KEY "OFF", ENGINE "OFF".
Disconnect APS connector .
Check resistance for each terminal refering to Resistance characteristic table.
Specification : Resistance characteristic table for each terminal
checking point | Resistance( KΩ 20℃ ) | Characteristic | ||
Pedal Depressed | Pedal Released | |||
APS 1 | power - ground | 1.0±0.1KΩ | 1.0±0.1KΩ | Unchanged |
power - signal | 1.8±0.1KΩ | 1.1±0.1KΩ | Resistance drops | |
signal - ground | 1.1±0.1KΩ | 1.8±0.1KΩ | Resistance rises | |
APS 2 | power - ground | 2.0±0.1KΩ | 2.0±0.1KΩ | Unchanged |
power - signal | 2.9±0.1KΩ | 2.1±0.1KΩ | resistance drops | |
1(signal)-2(ground) | 1.1±0.1KΩ | 1.8±0.1KΩ | resistance rises | |
Are resistances for each terminal measured correctly?
| ▶ Go to "Verification of Vehicle Rapair". |
| ▶ Replace APS and go to "Verification of Vehicle Rapair". |
