1.
Check injector component resistance
(1)
IG KEY "OFF", ENGINE "OFF".
(2)
Disconnect injector connector.
(3)
Measure the resistance between high side terminal and low side terminal of injector connector. (component side).
Specification : 0.255Ω±0.04 (20°C).
(4)
Is the measured resistance(of injector solenoid) within the specification?
 | ▶ Go to "Verification of Vehicle Repair". |
 | ▶ Replace injector and go to "Verification of Vehicle Repair". |
note
Replacing injectors, peculiar IQA code of each injector should be inputted to ECM.
Perform this process using "Injector data input" function on GDS, Refer to P1670, P1671 for more detailed information.
