7.
Maintaining ENG. RPM at 2,500RPM(idle) over 2 minutes.
Specification : Approx. 9~16V
Connect GDS to Data Link Connector(DLC).
Diagnose EPB with GDS for DTC and state information.
If it is historic DTC, perform actuation by GDS and check whether it is operating normally.
If it is active DTC, perform procedure below.
Start engine and turn the headight and the heatwire on.
Monitor the "BATTERY VOLTAGE" parameter on the GDS.
Maintaining ENG. RPM at 2,500RPM(idle) over 2 minutes.
Specification : Approx. 9~16V
Is parameter within specifications?
 | ▶ Fault is intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and Control Module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage. ▶ Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure. |
 | ▶ Go to "W/Harness Inspection" procedure. |
