10684358

Component Inspection

■ Back Up Switch Check

IG OFF

Disconnect the back up switch connector.

Measure resistance between ground terminal and signal terminal of the back up switch connector.

Specification :

Approx. below 1Ω (In case of pressing the back up switch)

Approx. ∞ Ω (In case of not pressing the back up switch)

Is the measured value within specifications?

	▶ Fault is intermittent caused by poor connection in back lamp switch harness connector. Go to "Verification of vehicle Repair" procedure.
	▶ Substitute with a known-good back up switch and check for proper operation. If problem is corrected, replace back up switch and then go to "Verification of Vehicle Repair" procedure.