Connect GDS to Data Link Connector(DLC).

Ignition "ON" & engine "OFF".

Selet "Currnet Data" mode and monitor "Inhibitor switch" parameter.

Change a shift lever from P-range to D-range.

Fig 1) P range

Fig 2) R range

Fig 3) N range

Fig 4) D range

Is the Inhibitor switch value chaged in specification?

	▶ P0705 can be happened When Shift Cable alignment is not correct between TGS Lever and Transmission Range Sensor. so Do not replace "Inhibitor Switch" and Check the Alignment of Shift Cable.
	▶ Go to "Shift cable alignment Inspection" procedure.

Move TGS lever to "N" position. and unfasten Shift cable - Manual Control Lever nut and Transmission Range sensor 2bolts.

Set Manual Control Lever in "N" position.

1. N setting hole(5mm)

2. Manual Control Lever

3. Shift Cable & nut(12MM)

4. Jig(5mm)

5. Transmission Range Sensor bolt(10mm)

Insert "N setting Jig(Φ5)" into the "N setting hole"

Fasten the Shift cable - Manual Control Lever nut and Transmission Range sensor 2bolts.

※ Beware of pull or push between Shift Cable and Manual Control Lever.

Remove the Jig from "N setting hole"

1. Good “N” alignment

2. Faulty “N” alignment

Is the problem solved?

	▶ Go to "Verification of Vehicle Repair" procedure.
	▶ Go to "Wiring Inspection" procedure.

Move shift lever "N" to "D" range.

Check the Shift lever is stop between "N" range and "D" range.

If the Shift lever is stop between "N" range and "D" range, replace Shift lever.

After complete above procedure, Move shift lever "P" to "D" range 2times.

1. Stop between "N" and "D"

2. Stop between "N" and "D"

Is the problem solved?

	▶ Go to "Verification of Vehicle Repair" procedure.
	▶ Go to "Wiring Inspection" procedure.