Component Inspection
■ Check Gear Switch
1.

Check Parking Position Switch

(1)

IG KEY OFF.

(2)

Disconnect Check Gear connector.

(3)

Measure resistance between one and the other connector when Check Gear ON and OFF.

Specification : Measurement 1 : Infinite (∞)

Measurement 2 : About below 1Ω

(4)

Is the measured resistance within specifications?

▶ Check for poor connection between Gear Switch and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "Verification of Vehicle Repair" procedure.

▶ Substitute with a known-good EPB ECU and check for proper operation. If the problem is corrected, replace EPB ECU and then go to "Verification of Vehicle Repair" procedure.

▶ Substitute with a known-good Gear Switch and check for proper operation. If the problem is corrected, replace Gear Switch and then go to "Verification of Vehicle Repair" procedure.

Яндекс.Метрика