Ignition "ON" & Engine "OFF"

Measure voltage between power terminal of PCSV harness connector and chassis ground.

Is voltage within the specification?

	▶ Go to next step as below.
	▶ Check for a open in the power supply circuit. Repair as necessary and go to "Verification of Vehicle Repair" procedure.

Ignition "ON" & Engine "OFF"

Measure voltage between control terminal of PCSV harness connector and chassis ground.

Is voltage within the specification?

	▶ Go to next step as below.
	▶ Check control circuit for open or short. Repair as necessary and go to "Verification of Vehicle Repair" procedure.

Many malfunctions in the electrical system are caused by poor harness(es) and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.

Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

Has a problem been found?

	▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure.
	▶ Check for poor connection between PCM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "Verification of Vehicle Repair" procedure.