4.
Maintaining ENG. RPM at 2,500RPM(idle) over 2 minutes.
Specification: less than 17 [V]
Connect GDS to Data Link Connector(DLC).
Start engine and turn the headight and the heatwire on.
Monitor the "BATTERY VOLTAGE" parameter on the GDS.
Maintaining ENG. RPM at 2,500RPM(idle) over 2 minutes.
Specification: less than 17 [V]
Is parameter within specifications?
 | ▶ Fault is intermittent caused by poor connection in power harness and/or TPMS ECU's connector or was repaired and TPMS ECU memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure. |
 | ▶ Go to "W/Harness Inspection" procedure. |
