10733858

1.

Connect GDS to Data Link Connector(DLC).

2.

Using GDS, clear DTCs.

3.

IG OFF and then, IG ON,again.

4.

Again using GDS, Check DTC present.

5.

Is the same DTC shown, agian?

▶ Substitute with a known-good TPMS ECU and check for proper operation. If problem is corrected, replace TPMS ECU and then go to "Verification of Vehicle Repair" procedure.

▶ After replacing with a known-good TPMS ECU(or TPMS Receiver), Write the Vehicle Name & VIN by GDS & TPMS Mode Configuration and Register the sensor ID by GDS TPMS tool.

▶ Fault is intermittently caused or was repaired and TPMS ECU memory was not cleared.

Go to "Verification of Vehicle Repair" procedure.