10733859

Many malfunctions in the electrical system are caused by poor harness(es) and terminal condition. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.

Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

Has a problem been found?

	▶ Repair as necessary and then go to "Verification of Vehicle Repair" procedure.
	▶ Go to "Charging System Inspection" procedure.

Measure voltage between terminal (+) and (-) of battery maintaining ENG. RPM at 2,500RPM(idle) over 2 minutes.

Specification : More than 10 [V]

Is the measured value within specifications?

▶ Go to "Power Circuit Inspection" procedure.

▶ Check that the tension of drive velt, ENG RPM, fuse, terminal of battery, all terminals of alternator are in good condition and Check for damaged harness and poor connection between alternator and battery.

▶ Repair as necessary and then go to "Verification of Vehicle Repair" procedure.

Measure voltage between battery power terminal of TPMS ECU harness connector and chassis ground maintaining ENG. RPM at 2,500RPM(idle) over 2 minutes.

Specification : More than 10 [V]

Is the measured voltage within specifications?

▶ Go to "Ground Circuit Inspection" procedure.

▶ Check for open or blown fuse referring to "Circuit Diagram".

Repair open or short in power circuit between battery and TPMS ECU harness connector and then go to "Verification of vehicle Repair" procedure.

Measure resistance between ground terminal of TPMS ECU harness connector and chassis ground.

Specification : Approx. 1.0 Ω

Is the measured resistance within specifications?

▶ Substitute with a known-good TPMS ECU and check for proper operation.

If the problem is corrected,replace TPMS ECU and then go to "Verification of Vehicle Repair" procedure.

▶ After replacing with a known-good TPMS ECU(or TPMS Receiver), Write the Vehicle Name & VIN by GDS & TPMS Mode Configuration and Register the sensor ID by GDS TPMS tool.

▶ Check for open or contact resistance in ground harness.

Repair as necessary and then go to "Verification of Vehicle Repair" procedure.