Component Inspection
1.

Connect GDS and select "Diagnostic Trouble Codes(DTCs)" mode.

2.

Using a GDS, Clear DTC.

3.

IG OFF → IG ON.

4.

After driving at 20 km/h for approx. 10~20 minutes, check if there is a DTC happened.

5.

Are any DTCs present ?

▶ Check if there is an extra tire installed. And if the sensor isn't in the extra tire, replace it with a new one and performs "Verification of a vehicle repair" procedure.

▶ Substitute with a known-good TPMS sensor and check for proper operation. If problem is corrected, replace it and then go to "Verification of Vehicle Repair" procedure.

▶ Fault is intermittently caused or was repaired and TPMS ECU memory was not cleared.

Go to "Verification of Vehicle Repair" procedure.

Яндекс.Метрика