Remove the front door trim.

(Refer to Body - "Front door")

Remove the front door module.

Disconnect the 7P connector from the actuator.

Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Remove the rear door trim.

(Refer to Body - "Rear door")

Remove the rear door module.

Disconnect the 7P connector from the actuator.

Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Remove the trunk lid trim panel.

(Refer to Body - "Trunk lid")

Disconnect the 3P connector from the actuator.

Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Remove the front door trim panel.

(Refer to Body - "Front door")

Remove the front door module.

Disconnect the 7P connector from the actuator.

Check for continuity between the terminals in each switch position when inserting the key into the door according to the table.

Remove the rear door trim panel.

(Refer to Body - "Rear door")

Remove the rear door module.

Disconnect the 7P connector from the actuator.

Check for continuity between the terminals in each switch position according to the table.

Remove the trunk lid trim.

(Refer to Body - "Trunk lid")

Disconnect the 3P connector from the actuator.

Check for continuity between the terminals in each switch position according to the table.